Abstract
In this study, we designed and manufactured a new Fe-bearing Al-10Si-Mg casting alloy (F alloy) and investigated its microstructure, mechanical properties, and thermal conductivity. Two types of Fe-bearing Al-10Si-Mg alloys were used: the Conventional-F alloy, injected at 720 ℃ and cooled by water quenching, and the Superheated-F alloy, heated to..... More

Abstract
The effects of Mg content and cooling rate on the T5 treatment of Al-Si-Mg alloys have been investigated using Avrami kinetics and transmission electron microscopy. The alloys were super-heated at 800 ^oC for 1 hr followed by degassing treatment at 720 ^oC for 15 min, and poured into a metallic..... More

Abstract
The elevated temperature strength of multicomponent Al-Si alloys is greatly affected by the volume fraction and the interconnectivity of hard phases formed upon solidification. In the present investigation, such influences were examined for two Al-Si-Cu-Ni alloys with different total volume fractions of hard phases. To control the microstructural features related..... More

Abstract
The influence of ultrasonic melt treatment (UST) combined with a change in cooling rates on the microstructure and elevated temperature mechanical properties of a hypereutectic Al-18Si-4Cu-3Ni piston alloy was investigated. Microstructural observation confirmed that UST effectively refined the sizes of primary Si and intermetallic compounds (e.g. ε-Al₃Ni) while promoting their..... More

Abstract
The effect of ultrasonic melt treatment (UST) on the microstructure and mechanical properties of Al-7Si-0.35Mg (A356) casting alloys was investigated. The particular aim of this study was to analyze the mechanism involved in the strengthening of the A356 alloys when fabricated by UST. The UST had little effect on the..... More