Abstract
It has been proposed that a primary water stress corrosion cracking (PWSCC) in pressurized water reactor (PWR) is governed by a lattice contraction due to a short range ordering reaction in Alloy 600. This leads researcher to think that the kinetics of lattice contraction may control a susceptibility of PWSCC..... More

Abstract
To automatically reconstruct the prior austenite grains from as-quenched martensitic structure, we applied a deep learning algorithm to recognize the prior austenite grains boundaries hidden in the martensitic matrix. The FC-DenseNet architecture based on FCN (fully convolutional networks) was used to train the martensite and ground truth label of the..... More

Abstract
The effects of the cooling rate, after solution heat treatment, on the microstructures and mechanical properties of Fe-22Mn-8Al-0.8C-0.02Nb (low carbon) and Fe-20Mn-8Al-1.1C-0.1Nb (high carbon) light-weight steels were systematically investigated. The cooling process was controlled to achieve six different cooling rates, ranging from -0.016 to -465.1 ^oC/s. Under the slowest cooling..... More

Abstract
In this study, oxide (Y₂O₃)-embedded Ni particles were fabricated via a new process. The process involves the mechanical hydrogenation of Ni–Y alloy into Ni–YH₂ and the selective oxidation of Ni–YH₂ to Ni–Y₂O₃. The alloy powders were prepared for sintering by the mechanical alloying of a mixed powder. The powder was..... More

Abstract
Generally, molds are fabricated by the machining of massive billets of tool steels, such as AISI4140 or H13, but it has drawbacks, such as a large material loss and long-delivery time. The Wire-Arc Additive Manufacturing (WAAM) process could be an alternative fabrication method. It has the advantages of less material..... More

Abstract
In this study, the effects of electrode surface design on the resistance spot weldability and degradation of the electrode following resistance spot welding (RSW) of aluminum 6014-T4 alloy were investigated. A new patterning method that can be produced through repetitive pressurization was applied to the electrode, producing a lattice-like pattern..... More

Abstract
In this study, the weldability of the as-cast CM247LC superalloy for turbine blade applications was metallurgically evaluated in terms of its hot cracking behavior and susceptibility. For this purpose, a real blade was manufactured using a directional solidification casting process, and gas tungsten arc welding was performed at the tip..... More

Abstract
Spinel ferrites (Ni_0.5Zn_0.5)_1-x-yCo_xCu_yFe₂O₄, (x = 0 and y = 0, x = 0.2 and y = 0, x = 0.1 and y = 0.1, x = 0 and y = 0.2) were prepared by sol-gel method and post-annealed at 1100 ^oC. The grain growth of the sample is very sensitive..... More

Abstract
Nickel hexacyanoferrate (NiHCF) has a three-dimensional open framework structure, excellent long-cycling stability and rate performance as a cathode for aqueous sodium-ion batteries. However, the specific capacity of NiHCF is lower than that of present cathodes for aqueous batteries. A sodium-ion electrolyte was explored to achieve optimum capacity with NiHCF. Powder-type..... More

Abstract
Solar water splitting is an attractive method for producing hydrogen from renewable natural resources, and heterostructure photocatalysts have been widely investigated for photocatalytic applications. Hetero-component photocatalysts can reduce the charge recombination process by improving electron utilization, and are considered promising candidates for solar water splitting. Amongst various heterostructure systems, combinations..... More