| Home | E-Submission/Review | Sitemap | Editorial Office |  
Korean Journal of Metals and Materials > Volume 54(9); 2016 > Article
Korean Journal of Metals and Materials 2016;54(9): 688-697. doi: https://doi.org/10.3365/KJMM.2016.54.9.688
첨가된 Ni이 저온 분사된 Al-Ni 복합체의 적층 상태에 미치는 영향
김재익, 이승태, 이창희
한양대학교 신소재공학과, 저온 분사 코팅 연구실 (NRL)
Effect of Added Ni on the Deposition State of Kinetic Sprayed Al-Ni Composite
Jaeick Kim, Seungtae Lee, Changhee Lee
Kinetic Spray Coating Laboratory (NRL), Division of Materials Science and Engineering, Hanyang University, Seoul 04763, Republic of Korea
Correspondence  Changhee Lee ,Tel: +82-2-2220-0388, Email: chlee@hanyang.ac.kr
Received: 14 March 2016;  Accepted: 7 April 2016.  Published online: 5 September 2016.
The liners of shaped charges, a type of weapon, should possess good penetration ability and explosive power. Conventionally this is achieved by fabricating reactive Al-Ni composite layers on the Cu liners, which by themselves have fine penetration ability but poor explosive power. However, there are no studies related to the deposition behavior and interfacial state of a mixed Al-Ni composite applied by kinetic spraying, despite its importance in terms of the effect on reactivity. Thus, this study investigated pure Al and mixed Al-Ni composites that were deposited by kinetic spray process and the effect of Ni on the deposition and interfacial bonding state. The deposition efficiency was degraded by addition of Ni, but the density and bond strength were enhanced with the increase in Ni fraction. The primary cause of the lowered deposition efficiency was insufficient particle velocity, with the intense effect of strain hardening of Ni. However, the tamping effect induced by harder Ni particles contributed to a reduction in pores, and improvement of the interfacial bonding state.
Keywords: Al-Ni composite, kinetic spray process, deposition behavior, interfacial state
Editorial Office
The Korean Institute of Metals and Materials
6th Fl., Seocho-daero 56-gil 38, Seocho-gu, Seoul 06633, Korea
TEL: +82-2-557-1071   FAX: +82-2-557-1080   E-mail: metal@kim.or.kr
About |  Browse Articles |  Current Issue |  For Authors and Reviewers
Copyright © The Korean Institute of Metals and Materials.                 Developed in M2PI