| Home | E-Submission/Review | Sitemap | Editorial Office |  
Korean Journal of Metals and Materials > Volume 55(11); 2017 > Article
Korean Journal of Metals and Materials 2017;55(11): 813-818. doi: https://doi.org/10.3365/KJMM.2017.55.11.813
실리콘 프레넬 렌즈 기반 트랜스미터 광모듈의 광정렬 설계 및 특성 향상 연구
황인엽1, 하준석2, 류상완1,2
1전남대학교 물리학과
2전남대학교 광전자융합기술연구소
Design of a Silicon Fresnel Lens for Optimized Light Coupling in a Transmitter Optical Subassembly
In Yup Hwang1, Jun-Seok Ha2, Sang-Wan Ryu1,2
1Department of Physics, Chonnam National University, Gwangju 61186, Republic of Korea
2Optoelectronics Convergence Research Center, Chonnam National University, Gwangju 61186, Repulic of Korea
Correspondence  Sang-Wan Ryu ,Tel: +82-62-530-3476, Email: sangwan@chonnam.ac.kr
Received: 16 May 2017;  Accepted: 31 July 2017.  Published online: 31 October 2017.
The silicon microlens is a key element in advanced optical packaging. However, the difficulty of its fabrication process and low yield have hindered the development of an silicon lens based optical device module. A silicon Fresnel lens was studied using ray tracing optical simulation, because its small sagittal height allows easy fabrication and high yield. The Fresnel lens was constructed from reference spherical lens with a controlled zone depth and partition number. The optimum zone depth was determined by target wavelength and the refractive index of the lens. The partition number was controlled for the highest coupling efficiency. The maximum coupling efficiency varied with the radius of curvature (ROC) of the lens and the coupling efficiency of the Fresnel lens was always higher than that of a reference lens. When the ROC was 700 μm, the Fresnel lens showed a coupling efficiency of -0.331 dB while the reference lens showed -0.674 dB. It was noted that the high coupling efficiency of the Fresnel lens could be obtained for a wide range of ROCs, which is huge advantage in the design of an optical module. The superior performance of the Fresnel lens was attributed to the smaller beam waist, as analyzed by the beam synthesis propagation method. The alignment tolerance of the Fresnel lens was similar to the reference lens in lateral offset, but it exhibited tighter tolerance with longitudinal offset.
Keywords: silicon lens, fresnel lens, optical packaging, coupling efficiency
Editorial Office
The Korean Institute of Metals and Materials
6th Fl., Seocho-daero 56-gil 38, Seocho-gu, Seoul 06633, Korea
TEL: +82-2-557-1071   FAX: +82-2-557-1080   E-mail: metal@kim.or.kr
About |  Browse Articles |  Current Issue |  For Authors and Reviewers
Copyright © The Korean Institute of Metals and Materials.                 Developed in M2PI