Abstract
The solidification and phase transformation behaviors of IN625 with low C and Fe were investigated through directional solidification and quenching experiments. The primary and secondary dendrite arm spacing decreased exponentially as the solidification rate increased, demonstrating good agreement with theoretical equations. The MC carbide formed at a constant temperature gradient..... More

Abstract
Cu-Ni-Si alloys were strengthened by Ni₂Si intermetallic compound precipitation in a Cu matrix during aging. The Cu-6 wt% Ni-1.4wt%Si alloy was prepared by water quenching (solution treatment) or air cooling (homogenization treatment) after heating 980 ^oC for 2 hours and aging at 500 ^oC for 6 hours. After maintaining a..... More

Abstract
Cu-Ti alloys were strengthened by Cu4Ti intermetallic compound precipitation in a Cu matrix during aging. The Cu-3.5 wt% Ti(Cu-4.6 at% Ti) alloys without deformation and with uniform and non-uniform deformation were aged at 450 oC for various times after solution treatment at 885 oC. The uniformly and non-uniformly deformed alloys..... More

Abstract
The CMSX-4 superalloy including refractory elements was directionally solidified using the seed of a [001] single crystal to control the growth direction to [001], where solidification velocity was changed from 25 to 160 μm/s. In the log-log plot between spacing and solidification velocity, the primary dendrite arm spacing and secondary..... More

Abstract
Directional solidification experiments were carried out to estimate the effect of solidification velocity and temperature gradient on primary dendrite arm spacing (PDAS) in the Ni-based superalloy, CMSX-4 alloy. The specimens were solidified at velocities of 1, 5, 25, 50 and 100 mm/s under given temperature gradients of 12.5, 18, 23..... More

Abstract
Martensitic 10Cr1MoW steels are widely used for high temperature components in turbine engines because they have good mechanical properties and corrosion resistance. Delta-ferrite can form locally in large ingots and the ferrite phase degrades the metal’s high-temperature properties. To decrease the fraction of delta-ferrite the solidification process should be controlled...... More

Abstract
The lamellar structure of two phases, the Zn-rich and Al-rich phases, is formed in a Zn-5 wt% Al eutectic alloy. In order to study the effect of microstructural changes on the tensile properties of eutectic Zn-Al binary alloy, Zn-Al and Zn-Al-Cu alloys were directionally solidified at a growth rate of..... More

Abstract
In order to study the effect of microstructural change on the tensile properties of discontinuous precipitated Al-Zn binary alloy, four different Al-Zn alloys(25, 30, 35, 45 wt% Zn) were aged at 160 ℃ for different aging times(0, 5, 15, 30, 60, 120, 360 min) after being solution treated at 400..... More

Abstract
Directional solidification of CM247LC was performed at a constant growth velocity (300 mm/h) using a Bridgman type furnace. Microstructural features, including the number of grains, PDAS, and EBSD IPF map, were investigated with progressive positions from the starter block. As directional solidification proceeded, the number of grains decreased and PDAS..... More