Abstract
In the present study, Cu₅₄Ni₆Zr₂₂Ti₁₈ bulk metallic glass composites were developed by spark plasma sintering(SPS) using gas atomized Cu₅₄Ni₆Zr₂₂Ti₁₈ metallic glass powders and Ta powders. Metallic glass composites with Ta phase were fabricated by SPS. The successful consolidation of Cu₅₄Ni₆Zr₂₂Ti₁₈ metallic glass matrix composites with the Ta phase was achieved..... More

Abstract
The powder microstructure and sintering behavior of W prepared by ultrasonic spray pyrolysis and spark plasma sintering were investigated. Fine-grained W powders were synthesized by ultrasonic spray pyrolysis using an ammonium metatungstate hydrate solution and hydrogen reduction. The XRD analysis of the powder, pyrolyzed below 600 ^oC, showed tungsten oxide..... More

Abstract
Blast furnace sludge, which comes from the iron making process, contains many valuable materials including iron, carbon, and zinc, etc. Because a cohesive agent is added during filtration, fine sludge particles are agglomerated together. Therefore, This makes it necessary to disperse the sludge in solution before separating or recovering valuable..... More

Abstract
In this study, we studied the surface and mechanical properties of multiple additives as well as the initial plating properties of individual additives. With the individual additive groups, copper crystals tended to converge at a stage above the critical amount of additive. When chloride ions were added, large crystals formed..... More

Abstract
Inkjet printing is a very attractive technology for printed electronics and a potential alternative to current high cost and multi-chemical lithography processes, for display and other applications in the electronics field. Inkjet technology can be employed to fabricate organic light emitting diodes (OLED), quantum dots displays, and thin-film transistors (TFTs)...... More

Abstract
Halide perovskite solar cells have been attracting tremendous attention as next-generation solar cell materials because of their excellent optical and electrical properties. Formamidinium lead tri-iodide (FAPbI₃) exhibits the narrowest band gap among lead iodide perovskites and shows excellent thermal and chemical stability, also. However, the large-area coating of FAPbI₃ needed..... More

Abstract
Mn-doped tetrahedrites Cu_12-xMn_xSb₄S₁₃ (0.1 ≤ x ≤ 0.4) were synthesized by mechanical alloying (MA) and sintered by hot pressing (HP). A single tetrahedrite phase was synthesized by MA without post-annealing, and it was stable without any phase changes after HP. The hot-pressed specimens had a relative density higher than 98.6%...... More

Abstract
Porous carbon has found commercial applications as a filter material based on the sorption ability of its pores. The pore size and surface properties of the carbon can be varied depending on the type of particles to be filtered. Here, mesoporous carbon was induced through the pyrolysis of polyvinylidene fluoride..... More

Abstract
A photo-rheological fluid (PRF) is a smart fluid which exhibits different viscosity under UV irradiation. A PRF is comprehensively presented in this work, with particular focus on its responses under UV off/on conditions. The isomeric conversion from SP to MC and vice versa under UV off and on, respectively, showed..... More